By Corraveni basin | 30 August 2019 | 0 Comments
How to Increase Toilet Flush Pressure
How to Increase Toilet Flush Pressure
Toilet designs haven't changed much over the years. Almost all home toilets contain a storage tank in the rear of the toilet that holds water above a flapper. When you flush the toilet, the flapper is raised, releasing water into the bowl and down the drain. There are a few things that can get in the way of strong flushing pressure, water level in the tank or clogged holes around the rim of the toilet bowl. Either way, there are some quick fixes that can increase the power of your toilet's flush.
Closed Water Valve
Toilets are fed water through a small valve that's located on the wall or floor near the back of the toilet. Make sure this valve is in the full "on" position for best performance. Turn the valve counterclockwise with your hand until it stops. Some models require only a quarter turn, while others require several full rotations to be fully open. A partially closed water valve can affect the fill performance of the tank.
Adjusting the Water Level
To flush properly, the water level inside the toilet tank needs to be set at the proper level. Remove the lid from the back of the toilet tank and check the water level to make sure that it sits about 1 inch below the overflow tube in the middle of the tank. If the water is lower, adjust the float inside the tank to raise the water level. For models that have a ball float, turn the screw on top of the fill valve clockwise to raise the water level. For models that contain a cylinder float valve attached to the fill valve, squeeze the clip on the side of the float and pull the float up until the water reaches the desired level.
Clogged Rims
Water travels into the bowl from the tank through a series of small holes positioned on the underside of the rim. If these holes become clogged with lime or other debris, the water will not enter the bowl with the same amount of force. Use a small mirror to view the underside of the toilet bowl rim. Inspect the holes around the rim for signs of clogging. Brush the holes vigorously with a nylon brush to clear any clogs and increase the overall flush performance.
Other Toilet Types
If the flushing power of your toilet just isn't enough, consider purchasing a new toilet that's designed with power in mind. A pressure assist toilet contains a bladder that holds water under pressure. These units cost more than traditional toilets, but have a very powerful flush. Vacuum assist toilets contain a plastic tank that creates suction in the tank when water is released, sucking waste out of the bowl. Either way, these units can have much more flushing power than standard toilets.
Leave a Reply
Your email address will not be published.Required fields are marked. *